- Toys
- >
- 3D Printed Snap-on XBOX gamepad HOTAS joystick
3D Printed Snap-on XBOX gamepad HOTAS joystick
Turn your Xbox One controller into a throttle-and-stick setup with these 3D-printed parts. A great addition to microsoft Flight Simulator
After printing, snap the parts together like in the video. The hinge pieces must be rotated 90 degrees, where their shaft is the thinnest, before snapping them in. Then slide in your controller.
Set your control stick to the right thumbstick and your throttle to the left trigger.
For extra spring tension, snake in a short rubber band through the special channels in the joystick mechanism.
A drop of vaseline or other grease in the joints makes the operation smooth and less noisy.
Check out the assembly and use video by the designer
Designed By Akaki Kuumeri. A Portion of all purchases go to the designers so that they can continue to create awesome stuff.